熱門產品：
產品分類 Products
聯系我們 Contact us
安平縣華耀智慧農業科技有限公司
聯系人：曹女士
電話：18503185891
Q Q：3059217513
微信：hengshuihuayao
網址：www.fhhyjy.com
地址：河北省衡水市安平縣
新聞中心
當前位置：網站***頁 > 新聞中心
安平縣華耀苗床廠_移動苗床_苗床網片_廠家批發價格
安平縣華耀苗床廠_移動苗床_苗床網片_廠家批發價格
苗床顧名思義就是用來放苗的床，其分為固定苗床和可移動苗床。固定苗床就是苗床固定在了種植溫室地面上，床面不可移動。手搖式移動苗床就是床面可以移動的床。由于固定苗床的土地利用率較低，因此逐漸被手搖式苗床所取代。
那么問題來了為什么要使用手搖式移動苗床呢？為什么不直接把盆花放在地上呢。
苗床顧名思義就是用來放苗的床，其分為固定苗床和可移動苗床。固定苗床就是苗床固定在了種植溫室地面上，床面不可移動。手搖式移動苗床就是床面可以移動的床。由于固定苗床的土地利用率較低，因此逐漸被手搖式苗床所取代。
那么問題來了為什么要使用手搖式移動苗床呢？為什么不直接把盆花放在地上呢。
1、苗床網的高度大約在0.6米高，加上盆花自有高度在一米左右，正好工人站著很自然的工作，不會很累。
2、苗床網將植物鏤空太高，形成上下的通風空間、不宜滋生細菌等。
3、由于大面積生產溫室一般都會安裝噴灌或者自走式水車來代替人工澆水，如果植物直接放在地下會長期泡在水中，容易導致根部腐爛。
4、移動式苗床土地利用率高，溫室跨度為8米，可以放4個1.8米也就是苗床實際是7.2米，溫室土地利用率為90%。
2. 由于紅掌原產地特性，決定了紅掌生長需要較高的空氣濕度。一般大棚養植培育過程中會將空氣濕度維持在百分之六十到百分之八十之間，想必家庭養護過程中則比較難達到這樣的條件，這個時候可以采用噴霧，加濕器來增加葉面和室內空氣相對濕度，從而創造適宜紅掌生長的環境，如果有條件，將紅掌放在熱帶雨林缸中養，那是再好不過哦。
3. 良好的光照是紅掌進行光合作用的必要因素，對它的葉色、花、佛焰苞的品質會有重要影響。室內養紅掌需要一定的散射光，可以放在臥室靠窗臺處，客廳明亮有散射光的地方等。夏天光照過強，建議不要放在室外直曬，否則可能造成葉片變色、灼傷或者焦枯的現象，到時后果不堪設想。
4. 紅掌喜歡濕潤的環境，不要等它的基質都干透了才知道澆水，一般在盆土微干時就可以進行澆水了，記得始終保持土壤是濕潤的狀態，自來水不建議使用。
5. 如需施肥，可選擇高磷鉀肥，能促進開花，結合澆水一起使用。一次性不能施肥太多，薄肥勤施***好。
6. 紅掌的基質選擇疏松透氣的粗泥炭混合細泥炭，粗細比例1:1左右比較合適，再混合少量整株巖。如果是剛買回來的紅掌建議不要立即換盆種植，***好是等植株長大，根系長滿后再換大盆養。
如何養好紅掌？
1. 紅掌生長適宜溫度為18攝氏度-28攝氏度，溫度太低容易發生凍害。如果所在環境中冬天沒有霜凍，紅掌基本不會死。溫度太高，紅掌能量消耗太大，佛焰苞容易褪色，所以夏季注意保持通風降溫，多噴水。2. 由于紅掌原產地特性，決定了紅掌生長需要較高的空氣濕度。一般大棚養植培育過程中會將空氣濕度維持在百分之六十到百分之八十之間，想必家庭養護過程中則比較難達到這樣的條件，這個時候可以采用噴霧，加濕器來增加葉面和室內空氣相對濕度，從而創造適宜紅掌生長的環境，如果有條件，將紅掌放在熱帶雨林缸中養，那是再好不過哦。
3. 良好的光照是紅掌進行光合作用的必要因素，對它的葉色、花、佛焰苞的品質會有重要影響。室內養紅掌需要一定的散射光，可以放在臥室靠窗臺處，客廳明亮有散射光的地方等。夏天光照過強，建議不要放在室外直曬，否則可能造成葉片變色、灼傷或者焦枯的現象，到時后果不堪設想。
4. 紅掌喜歡濕潤的環境，不要等它的基質都干透了才知道澆水，一般在盆土微干時就可以進行澆水了，記得始終保持土壤是濕潤的狀態，自來水不建議使用。
5. 如需施肥，可選擇高磷鉀肥，能促進開花，結合澆水一起使用。一次性不能施肥太多，薄肥勤施***好。
6. 紅掌的基質選擇疏松透氣的粗泥炭混合細泥炭，粗細比例1:1左右比較合適，再混合少量整株巖。如果是剛買回來的紅掌建議不要立即換盆種植，***好是等植株長大，根系長滿后再換大盆養。
育苗移動苗床-生態蔬菜育苗移動苗床的規格：
苗床設計寬度1.4m,長度38m,高度0.75m,每跨設4組,總計24組
苗床立柱、橫梁采用40×30×1.5mm的矩形管,床面四周采用鋁合金邊沿,網片所有材料都采用熱鍍鋅處理。
材質:優質低碳鋼絲
絲徑：4.0mm /3.0mm
網孔：120 mm×25mm 130mm×30mm 50mm×50mm
尺寸：1.9m×4m
Mobile seedbed for seedling raising - Specifications of mobile seedbed for ecological vegetable seedling raising:
Anping Huayao seedbed factory_ Moving seedbed_ Seedbed mesh_ Wholesale price of manufacturer
As the name implies, seedbed is used to put seedlings, which is divided into fixed seedbed and movable seedbed. Fixed seedbed means that the seedbed is fixed on the ground of planting greenhouse, and the bed surface cannot be moved. Manual moving seedbed is the bed with movable surface. Due to the low land use efficiency of fixed seedbed, it is gradually replaced by hand-held seedbed.
So the question is, why use a mobile seedbed? Why not just put the potted flowers on the ground.
1. The height of the seedbed net is about 0.6 meters high, and the height of potted flowers is about 1 meter. It is just that the workers are standing very naturally and will not be very tired.
2. The seedling bed net hollows out the plants too high, forming a ventilation space above and below, and not suitable for breeding bacteria.
3. Due to the large-scale production greenhouse will generally install sprinkler irrigation or self-propelled water truck instead of manual watering. If plants are directly placed underground, they will soak in water for a long time, which is easy to cause root rot.
4. The mobile seedbed has a high land utilization rate. The greenhouse span is 8 meters, and 4 1.8 meters can be placed. That is to say, the actual seedbed is 7.2 meters. The land utilization rate of greenhouse is 90%.
How to raise Anthurium andraeanum?
1. The suitable temperature for Anthurium andraeanum growth is 18 ℃ - 28 ℃. If the temperature is too low, it is easy to cause freezing damage. If there is no frost in winter, Anthurium andraeanum will not die. If the temperature is too high, the energy consumption of Anthurium andraeanum is too high, and the spathe is easy to fade, so pay attention to keep ventilation and cool down in summer and spray more water.
2. Because of the origin characteristics of Anthurium andraeanum, the growth of Anthurium andraeanum needs higher air humidity. In general greenhouse cultivation, air humidity will be maintained between sixty percent and eighty percent. It is difficult to achieve such conditions in the process of family maintenance. At this time, spray and humidifier can be used to increase the relative humidity of the leaf and indoor air, so as to create suitable environment for the growth of Anthurium. If conditions permit, the Anthurium should be placed in the tropical rain forest tank. That would be great.
3. Good illumination is a necessary factor for photosynthesis of Anthurium andraeanum, which has an important influence on the leaf color, flower and spathe quality. Indoor cultivation of Anthurium andraeanum needs a certain amount of scattered light, which can be placed in the bedroom by the windowsill, and the living room where there are scattered light. If the light is too strong in summer, it is recommended not to put it in the direct sunlight outdoors, otherwise it may cause discoloration, burn or scorch of the leaves, and the consequences will be unimaginable.
4. Anthurium andraeanum likes humid environment. Don't wait for its substrate to be dry before watering. Generally, watering can be carried out when the basin soil is slightly dry. Remember to keep the soil moist all the time. Tap water is not recommended.
5. If fertilization is needed, high phosphorus and potassium fertilizer can be selected, which can promote flowering and be used together with watering. It is better to apply thin fertilizer frequently.
6. The matrix of Anthurium andraeanum is composed of loose and breathable coarse peat mixed with fine peat, and the ratio of coarse peat to fine peat is about 1:1, and then a small amount of whole plant rock is mixed. If it is a newly bought Anthurium andraeanum, it is recommended not to plant it in pots immediately. It is best to wait for the plants to grow and the roots to grow up.
Mobile seedbed for seedling raising - Specifications of mobile seedbed for ecological vegetable seedling raising:
The design width of the seedbed is 1.4m, the length is 38m and the height is 0.75m. There are 4 groups in each span, with a total of 24 groups
The column and crossbeam of seedbed are made of 40 × 30 × 1.5mm rectangular tubes. The edge of aluminum alloy is used around the bed surface. All materials of mesh are hot-dip galvanized.
Material: high quality low carbon steel wire
Wire diameter: 4.0 mm / 3.0 mm
Mesh: 120 mm × 25 mm 130 mm × 30 mm 50 mm × 50 mm
Size: 1.9m × 4m
版權所有 安平縣華耀智慧農業科技有限公司
聯系人：張女士 電話：18503185891 Q Q：3059217513 微信：18503185891
網址：www.fhhyjy.com 地址：河北省衡水市安平縣 冀ICP備19015047號-2
微信二維碼